Brush Cutter Assembly and Installation Guide

ASSEMBLING DRIVE SHAFT

Release the bolt (3) and remove it with the washer (5).
Insert the flexible shaft (1) into the joint pipe (2) of Drive Shaft to the end and tighten the bolt (3) with the washer (5) by engaging the bolt to the slot (4) of flexible shaft.

NOTE: Make sure to align square end of flexible inner shaft with square hole of drive shaft by slightly rotating drive shaft so that they are connected firmly.

 

INSTALLING FLEXIBLE SHAFT ASS’Y AND CLUTCH ASS’Y

Put flexible shaft square-head in square hole of clutch case, raise the pin, aim the hole of flexible shaft at orientation hole of cluoh case. then put down the pin.

 

INSTALLING MAIN CABLE COMP AND SUBORDINATE CABLE COMP

Get the main cable comp go to slot of the subordinate cable comp.Then put both of them on the appropriate location of the joining as shown.

 

INSTALLING HANDLE
Install handle in bracket.Position handle in a comfortable operating position and
tighten four M5x25 screws.

 

INSTALLING PLASTIC SHIELD

Install the safety cover on the shaft with the safety cover bracket and the screws
provided. Tighten the screws after setting the safety cover bracket at the appropriate position.

 

If you still have problem installing all of it, see this another version of complete brush cutter user guide below(click to enlarge image).

 

This entry was posted in Brush Cutter Installation and tagged , . Bookmark the permalink.

One Response to Brush Cutter Assembly and Installation Guide

  1. hisham says:

    This machine TL33 at lelong made in china,korea or japan…?
    Your location..? Email..?
    Tq